My multi-color 3D prints stopped wasting filament when I gave up on printing large parts in one go
When I got my first FDM 3D printer, I didn’t care all that much about filament purge. Sure, the printer would leave randomly extruded bits of filament to prime the nozzle, but I was more concerned with failed models, as they were the primary source of filament waste for my setup. Multi-color printing, however, is a completely different story, and it wasn't until I tried using an AMS-like module that I finally realized why 3D printing enthusiasts have mixed feelings about these setups.
When I got my first FDM 3D printer, I didn’t care all that much about filament purge. Sure, the printer would leave randomly extruded bits of filament to prime the nozzle, but I was more concerned with failed models, as they were the primary source of filament waste for my setup. Multi-color printing, however, is a completely different story, and it wasn’t until I tried using an AMS-like module that I finally realized why 3D printing enthusiasts have mixed feelings about these setups.
John Doe
New York
New York
Published by: aplhsindia.in
